Brands and countries
  • Product

M105 ELASTOSOL

Elastosol
SDS
Product overview
Elastosol M105 is a room temperature applied, low viscosity paste, based on sulphur cured polybutadiene. Elastosol M105 contains solid glass beads that act as spacers during the hemming process to control glue line thickness and prevent adhesive from being squeezed out of the joint. The glass beads are totally inert in all other respects and have no effect, either on the rate of curing or on the modulus of the cured product. Elastosol M105 is free from chlorine and does not contain epoxy
Available sizes
CARTRIDGES 310 ML/C12
DRUMS 28 KG/P18
DRUM(S) 280 KG/P2
Key Benefits
  • Contains glass beads that prevent excess adhesive from being squeezed out during the hemming process
  • Adheres to a wide range of metal substrates
  • Contains no volatile solvents
  • Cures at paint stoving temperatures
  • Does not produce corrosive by-products during curing
  • Excellent chemical resistance
  • Excellent resistance to overbaking
  • Does not contain epoxy
Adhesive Technology ELASTOSOL
Colors Black
Adhesion Typical result 10 Cohesive failure [Mpa] (stoving conditions 30 minutes at 180°C. Bond 12 x 25 x 0.17mm substrates mild & electrogalvanised steels)
Temperature Resistance The physical properties of Elastosol M105 vary according to temperature, but it retains good cohesive strength over a wide temperature range.
Viscosity Approx. 7.5
Chemical Resistance Elastosol M105 is resistant to water, common salt, ethylene glycol, oil and petrol in its cured state. Continuous immersion in petrol will swell the cured polymer.
Relative Density Approx. 1.7
Important Before embarking on any work involving Elastosol M105 the safety data sheet should be carefully studied by those carrying out the work.
Recommended Use Elastosol M105 has been developed as a high strength metal to metal adhesive for use in the automotive industry.
Shelf Life 17 months from date of manufacture, unopened in original container stored under the above conditions.
Storage
  • M105, like all Elastosols, must be protected from rain, snow and extreme heat.
  • The drums should not be stored outside where there will be potential for water ingress to occur.
  • M105 should be stored unopened in a cool dark place at no more than 20°C in order to preserve the 12 month shelf life from date of manufacture.
  • Please note:
    if the storage temperature is very low, the product must be allowed to warm up to ambient temperature prior to application.
Method Of Use

APPLICATION

  • Elastosol M105 may be applied using conventional air-operated pumps. NOTE: Elastosol M105 contains abrasive glass beads that will wear out pumping equipment and nozzles at a greater rate than would normally be expected.

ADHESION AND CURE CONDITIONS

  • Elastosol M105 adheres to a wide range of metal substrates and tolerates light coating s of mill or drawing oils (2-4 g/m2).
  • The minimum stoving condition to obtain good adhesion is 30 minutes at 160°C. Shorter times are acceptable at higher temperatures.
  • With Elastosols, over-baking does not lead to loss of adhesion.

OVERPAINTING

  • Elastosol M105 can be over painted with oil based,cellulose based or stoving enamels but does not accept electrocoat paint

Related market & applications

Automotive

Top